Oh no not another 8210 question!!!

I'm sur it's been asked a million times but i would appreciate it if someone would point me in the right direction.

I have an 8210 v5.28 that I want to unlock. I have a Flasher cable(the type that fits on the printer port).

I was going to use Jetro 3.11 and link the two pins 7 & 12 in the cable, however I notice in the about for jethro that it only supports up to 5.26. Will it still work??

If not whats my next best move - use a partial etc?? I have done this once before but i would not say i'm over confident (Do you have a good Tut)

Should I order another cable instead??

Thanx

Hi Stu...

i dunno about jethro....if it says it can only do 5.26 i would not chance it....

but you may want to download rolis 4.78 (its a sticky thread in the download section)... i think it will do 8210 v5.28... and it will working fine with the Dejan cable you have..(i dont think u need to link the pins together...) someone with more knowlegde then me will be able to verify my post..

i will find the link for you and post it here.. for rolis..

have a read on this thread..
http://digital-forums.com/forum/show...threadid=63109

it will be about half way down.

Good luck

Cheers.

thanx mate - thought you needed a serial cable for rollis??

as far as i know.. it does use the LPT1 port in the options bar at the top.... i am very certain it uses the parrallel port...just see if u can read ya phone :)

it like windows98.. but if u set compatibility mode... under xp.. then it should be ok (ive dumped a copy of my 6210 with it.) :)

cool thanx mate - you need to remind me how to get into compatability mode though

um......
if you press F1 on your desktop...
and then... in the find box, click and enter compatibility mode... and do a search... it will be there....

*its the only way i know to find it* as i seldom use it..

u may or may not need userports (in the same thread)...see if u can read the phone..if u cant.. download/install and run userports and start it, it should be fine after that...

Good luck ;)

easier than that - just right click on a program, and click on the compatibility tab from there:)

ive just used nokia tool by jordik and did it through a data cable (com port) and un locked it (version 5.29)

cas