help lost a pad on my liteon drive!!!

please can someone help me...

i was trying to bridge the points on my liteon drive so i could dump the key. its gone a bit wrong....

one of the pads has come off and can no longer bridge the point...

can anyone help me out, i can send the drive and pay the going rate, i also need someone to provide i drive to put the key onto it so i can use it. i will pay the going rate for that as well as p&P

i have a hitachi 47d and a samsung m25 that could be used...

please can someone help, really need to get this sorted...

thanks alot

BP:(

Bullet,

All you have to do is get a piece of wire (Kynar) and put one end in the hole beneath the 2 pads you are bridging. If its the left pair you have lost, put the wire in the hole and solder the other end to the top pad near the Sata ports RxD. Connections.

Or the right pads put the wire in the hole beneath and then solder the other end to the bottom TxD pad.
http://www.devilsps3.centelia.net/li...s/image002.jpg

-=AD=-

hi mate

thanks alot for the reply, not sure about putting wire through the hole, never done it before. if i was to mess that up i could be stuck with a knackered drive...

i think i may need to find someone who could do it for me...

Thanks alot

bp

Ill sort it for you if you like....anywhere near Blackpool / Preston ?

i can also do mate if you want but its rrealy not that hard to do bit of keynar wire tip the end with solder and place in the hole it works a treat

thanks alot guys for all the offers, vgopal has offered to help...

thanks once again

BP:)

AD, just for info, the "left pair" do not need to be bridged, only the "right pair" is actualy required.

Quote:

---

Originally Posted by AD

Bullet,

All you have to do is get a piece of wire (Kynar) and put one end in the hole beneath the 2 pads you are bridging. If its the left pair you have lost, put the wire in the hole and solder the other end to the top pad near the Sata ports RxD. Connections.

Or the right pads put the wire in the hole beneath and then solder the other end to the bottom TxD pad.
http://www.devilsps3.centelia.net/li...s/image002.jpg

-=AD=-

---

Quote:

---

Originally Posted by tronads

AD, just for info, the "left pair" do not need to be bridged, only the "right pair" is actualy required.

---

Unless you want to go back in the drive when the firmware is finally released, I do both.

-=AD=-

I know the drive has been flashable for quite a while now (just there is nothing yet to flash to it), but I hadnt heard that the flash method was going to be through the serial interface....have you heard this is definitely going to be the case ? I might as well start bridging the other point again while im in there if thats the case I guess.

I only made the point anyway because the OP was just concerned about getting his key, and therefore only needed to be advised on the minimum to get him fixed up.

AD, you have probably read by now that c4e says the flashing is sata, and only the key extraction is serial. You can move to only working on one point now.....should save you about 10 seconds ;-)