3310 Help

[Termy]

A m8 has just brought 2 3310's that he had tried flashing, so I connected them up and tried to reflash them. But no luck as the fones wont power on and Xpmobile s/w comes up with the error "cannot prepare phone"

Can anyone give me any suggestions or repair them for me.

[sc0use]

have you tried knok phonix softwere m8 ??? when you start the program try plugging in the power lead if not im on the wirral if you want me to have a look ???

[the_wizzard]

what dose rolis do??

[Termy]

what dose rolis do??

I have tried Rollis and it doesnt do anything m8 as the fone wont power uo.

have you tried knok phonix softwere m8 ??? when you start the program try plugging in the power lead if not im on the wirral if you want me to have a look ???

"cannot prepare phone"
That is the message that I get m8.

Can you pm me your addy and I will send them to you as I have not had muck luck flashing fones since I went to XP. Also let me know how much to repair them.

Many thanx for the replies.

[jojo]

try setting your lpt port to epp/ecp then clean up the phone connector pads (a slight waxy glaze is enough to cause no contact). open the program with the phone already plugged into the lpt dejan flasher set, do not attempt to power the phone until you are ready to flash and you are asked to power on. if all this fails try to do a full erase with knok, make sure the programs lpt ports are set ( sometimes a reboot solves the problem ) also make sure you pick the right phone, even though it says its a 3310 it could be a 3330 this will also prevent it from connecting.......good luck and dont give up its good to learn

[jojo]

p.s. when program asks you to power on phone try putting a power supply into the bottom of the phone this sometimes excites the circuit and acts like the power button has been switched on

[Termy]

try setting your lpt port to epp/ecp then clean up the phone connector pads (a slight waxy glaze is enough to cause no contact). open the program with the phone already plugged into the lpt dejan flasher set, do not attempt to power the phone until you are ready to flash and you are asked to power on. if all this fails try to do a full erase with knok, make sure the programs lpt ports are set ( sometimes a reboot solves the problem ) also make sure you pick the right phone, even though it says its a 3310 it could be a 3330 this will also prevent it from connecting.......good luck and dont give up its good to learn

Hehe, thatnx for that m8, I do however know how to flash fones
but have had no luck with s/w since going from M.E to XP. I am building a machine with M.E on it for this purpose.

Thanx for all the help,,, I think this will be sorted very soon.

[Termy]

All sorted now, thanx to a Win 98 machine.

[sc0use]

okm8 no problem