I've been having problems for ages since upgrading to MAXADSL basically when I was first on the service I was getting speeds of between 500 - 800k /sec and that was fantastic but that was short lived and then came the reality. I was one of the first to get maxadsl so was all good in my part.
Now here's the problems I am experiencing, slow speeds, I assume (and I will post all my configs etc etc from my router at the bottom of this post) I am doing everything correctly and should be getting faster speeds as I connect at usually 4032 Kbps down and 832 up. Now I know its not the ISP as it happened when I was with ace-internet and even now with ukfsn.
Up until last week I tolerated it as I was getting 350 KB/sec and that was me but I know for 100% I should be getting faster than that but now all I am getting is max 175, never ever goes past that as if its a limit.
Now I'll stop boring you with all the groans and moans and post what I need to post for some intelligent person to say I am a tit and that I am infact doing something totally wrong which is making my line go so slow, so here goes:
DSL Status : Up
DSL Modulation Mode : GDMT
DSL Path Mode : INTERLEAVED
Downstream Rate : 4032 Kbps
Upstream Rate : 832 Kbps
Downstream Margin : 2147483647 db
Upstream Margin : 9 db
Downstream Line Attenuation : 55
Upstream Line Attenuation : 29
Downstream Transmit Power : 0
Upstream Transmit Power : 0
PVC Connection
Encapsulation : RFC 2364 PPPoA
Multiplexing : VC
QoS : UBR
Pcr Rate : 0
Scr Rate : 0
Autodetect : Disable
VPI : 0
VCI: 38
Enable : Yes
PVC Status : Applied
Internet Connection
Login Type: PPPoA
Interface : Up
IP Address : 87.127.37.129
Subnet Mask : 255.255.255.255
Default Gateway : 87.127.229.6
DNS 1 : 195.74.113.58
DNS 2 : 195.74.113.62
DNS 3 : 0.0.0.0
WINS : 0.0.0.0
Encapsulation: PPPOA
VC Settings
Multiplexing: LLC VC (vc is selected here)
Qos Type: UBR
Pcr Rate: cps
Scr Rate: cps
Autodetect: Enable Disable
Virtual Circuit: 38
VPI (Range 0~255) 0
I just reset the router to make sure that it wasn't something on the line and when I conncted it up again I got the same speeds which majorly pissed me off...
So can anyone figure out whats wrong/what I am doing wrong.
Cheers,
Tam.
Social Networking Bookmarks