nexus cyclone unlooper (Red)

[jahbarrie]

Hi would appriciate any help on this. trying to use this unlooper T911 nexus cyclone unlooper (Red) got it hooked up using 6v 300mA adapter loaded XpAtmel and changea switches to 1 & 6 on then when i flash it with D11 it ccomes up wit
Hex Files Loaded
Initializing...
Initialized
Syncing...
Failed: Could not find active Atmel
Complete!
i got two tut one said use 1-5 on and another says 1&6 not sure which is right.

[BEZO]

i think dip-switch settings! 1-6 down should be for flashing (this is first and sixth dip-switch) and it is 2-5 down for glitching




bezo

[jahbarrie]

i think dip-switch settings! 1-6 down should be for flashing (this is first and sixth dip-switch) and it is 2-5 down for glitching




bezo

I've used 1&6 to flash but gets the same message when i do it
Hex Files Loaded
Initializing...
Initialized
Syncing...
Failed: Could not find active Atmel
Complete!
In the tut it mentioned something about a black switch that should be turned to the left i do not c a black switch on mine but it has a white key switch that would have to use a screwdriver to turn i have not touched that but is that suppose to be adjusted as well? aI also got a diode with the unlooper anyone knows what this is for? any help appriciated thanks.

[juddaman]

hi any help at all with this tryin to set this up is becoming a nightmare plz plz plz,There must be away or some kind person who uses this cyclone red.