How to Jailbreak Your 2.x.x 3G iPhone Using QuickPwn (Windows)

[kracken]

How to Jailbreak Your 2.x.x 3G iPhone Using QuickPwn (Windows)

These are instructions on how to jailbreak your 3G iPhone to the 2.1-2.2.1 iPhone firmware using QuickPwn for Windows.

If you are intending to unlock your iPhone you can use this tutorial to jailbreak ONLY if you are on the 02.28 baseband or lower AND you restore to 2.2 (NOT 2.2.1). If you use this tutorial to restore and to jailbreak firmware 2.2.1 there is no unlock currently available.

Step One
Create a folder called Pwnage on your desktop.

Download the following files and place them in the Pwnage folder you just created:

- QuickPwn-225-2.zip

FOR THOSE WHO WANT TO UNLOCK:
- 2.2.0 (3G): iPhone1,2_2.2_5G77_Restore.ipsw

FOR THOSE WHO DO NOT WANT TO UNLOCK:
- 2.2.1 (3G): iPhone1,2_2.2.1_5H11_Restore.ipsw

Extract the QuickPwn-225-2.zip file to the Pwnage folder.

Step Two
Connect your iPhone to the computer and launch iTunes.

Select your iPhone from the list of devices on the left. Now hold down shift and click the Restore button. Restore is preferred as it won't create any wasted space on your iPhone.

Navigate to the Pwnage folder on your desktop and select the firmware ipsw. Click the Open button to continue.

Step Three
Once iTunes has finished updating your iPhone to the desired firmware you may launch QuickPwn.exe from the Pwnage folder on your desktop.

Step Four
Make sure you iPhone is connected to the computer and click the blue arrow to continue.

Step Five
Click the Browse button to locate your iPhone firmware.

Step Six
Select the firmware ipsw from the Pwnage folder on your desktop then click the Open button.

Step Seven
QuickPwn will check to make sure the ipsw is valid. Click the blue arrow button to continue.

Step Eight
You can now select whether to Add Cydia, Add Installer, or Replace Boot Logos. Select the ones you would like to perform then click the blue arrow button

Step Nine
QuickPwn will now ask you to confirm your iPhone is connected via USB before continuing. Click the blue arrow button to proceed.

Step Ten
QuickPwn will now automatically put your iPhone into recovery mode. Once its in recovery mode you will be prompted to: Hold the Home button for 5 seconds, Hold the Home and Power buttons for 10 seconds, then release the Power button and continuing holding the Home button until your iPhone is in DFU mode.

Watch the prompts carefully and follow along.

Step Eleven
Once QuickPwn detects your iPhone in DFU mode it will begin the jailbreak process.

Step Twelve
Once jailbreaking is complete QuickPwn will inform you that it was successfull.