Peugeot 307 2003 BSi programming

[dave11674]

hi guys

had one of these in today to do

couldn not find a pic in my book to do it anywhere
the usual bsi pic for the 307 did not match it
so stripped out the pcb and found the ST 95160 eeprom
tried reading this with v1 v2 & v3 in my dashfixer
none would read a milage
all came back as 000000

any1 any ideas on what i could do to get it done ?

the clocks are sagem which i wont have a problem doing them with the NEC board i have.

thanks in adv

dave

[dave11674]

s'ok now i sorted it

to do these you need to open the BSi up and desolder one side of the pins that hold it to the big main board that has the glue sealant on it.
fold it over gently and you will find the 95160 eeprom next to CPU

short xtal or blob solder across the 2 pads near it (follw tracks to CPU)

easy as pie when you know how

dave

[Dashradio]

There is a pic of the solder on point so that you don't have to desolder the board

Rob