mi m8t`s
i need a icprog dude to clear a few things up for me. ( 12c509 )
i have created a superhex3 file from my serial number using the old F2 display trick. now assuming i created this correctly ( how can i tell? ) i have moved onto the next brick wall, ICPROG.
OK, so i have found that i can set the hardware settings for my "baby" programmer to "JDM", selecting the com port.... all well and good.
BUT> this is where the fun stops....
1 i`ve read the chip,,
2 i`ve opened the HEX file
3 i`ve tried to note the numbers i need for the end.... not sure which numbers though... any idea?
4 i`ve checked wdt, selected intrc
5 tried adding what i believe to be the important number.. is that the ID value? i don`t know to be honest? really am guessing here
6 i`ve tried to program....... get a "no oscillator callibration, value not found, use value from file?"......said yes
7 waited one hour and when it varified,it failed at 0000h
8 tried again with verify during program(saves an hour) and fails 0000h
9 used "blank check" ,,,, says its blank
10 ahh,,, but are the chip pins in the correct way on the baby. I DONT KNOW>>>>>>>>>
what else mught it be?
please help?
Social Networking Bookmarks