This tutorial can be used to jailbreak before applying the BlackSn0w unlock to your device.
Step One
Create a folder on your desktop called Pwnage
Download RedSn0w from
here and place it in the Pwnage folder.
Likewise, download the latest 3.1.2 firmware
from below and place it in the same folder.
Extract the RedSn0w application from the RedSn0w zip file to the Pwnage folder.
Step Two
Connect your iPhone to the computer and launch iTunes.
Select your iPhone from the list of devices on the left.
Now hold down shift and click the
Restore button.
Restore is preferred as it won't create any wasted space on your iPhone.
Navigate to the Pwnage folder on your desktop and select the firmware ipsw.
Click the
Open button to continue.
Step Three
Once iTunes has finished updating your iPhone to the desired firmware
you may launch
redsn0w.exe from the Pwnage folder on your desktop.
Step Four
Once RedSn0w opens click the
Browse button
Step Five
Select the firmware ipsw we placed in the Pwnage folder
on our desktop then click
Open
Step Six
Once the firmware has been verified click the
Next button to continue.
Step Seven
From this window you can select the jailbreak options you would like.
If you have already pwned your device check the
Already pwned option.
Verbose boot displays detailed information on boot of your device
and is generally only needed by developers and advanced users.
Make sure Cydia is selected. For this tutorial
we will also select Custom boot logo and Custom recovery logo.
When you click to select each custom logo option a dialog window
will appear asking you to select the image. Locate the image
you would like to use then press the
Open button.
*Remember the rules for boot logos are: RGB or Grayscale format
with Alpha channel and dimension below 320x480.
Click the
Next button to continue
Step Eight
Please plug your iPhone into the computer and make sure
its OFF then click the
Next button
Step Nine
RedSn0w will now guide you through the steps to get into DFU mode.
Hold down both the
Home button and the
Power button for 10 seconds.
Release the
Power button and continue holding the
Home button
until RedSn0w detects the device.
Step Ten
Your iPhone will now reboot
Step Eleven
RedSn0w will then begin uploading the new RAM Disk and Kernel.
Step Twelve
Once this is complete you will be notified that RedSn0w is done.
Click the
Finish button. After your iPhone finishes rebooting
(5 minutes or so), it will be jailbroken with Cydia on the SpringBoard.
*As usual a big thanks to the iPhone Dev-Team for their contribution to the community!
Social Networking Bookmarks