K heres my problem. I repaired a rrod falcon and it is jtagable, connected my nand x and got two good dumps. I then proceeded to connect the jtag wires but in my haste i didnt connect a diode to the rol board, just a wire ( i use the contact on the underside of the mobo ) I did connect a diode to d1f1. tried to flash xell and now i get an "could not detect a flash controller" i know my nandx is fine. so my question is have i fcked up this one? ive tried using an external power source to read the nand ,but nothing has worked so far. Any ideas?
Forgot to say it boots fine into the standard dash.
Social Networking Bookmarks