Lightwave 7.5 patch sending data?

**Drat911** · 11th September 2002

I installed the Lightwave 7.5 patch over my 7.0, and used the: "NEWTEK.LIGHTWAVE.3D.V7.5.FINAL-MiDNiGHT_CRACK_ONLY" patch on it.

Replaced 2 program files, and replaced a license.reg key. When I start up Lightwave 7.5, norton firewall asks if modeler.exe can send information to it's website.

I, being paranoid, blocked it. Now whenever it starts, it will remain frozen, trying to send data.

WHAT kind of data is it sending?? Reg info?? Any information on this?

**CyBorx7** · 12th September 2002

It does not send any data out of your computer.
LW Modeler and Layout communicate via TCP through the HUB that starts up as well when you start the modeler or layout.
Open the firewall and delete the Rule you made to block LW communication... then start LW again and allow the communication.. if you dont trust that, unplug yourself from the web, start up LW and you will see it will work fine when you allow it thruogh firewall.

**Shadow81** · 13th September 2002

Your IP has been sent to Interpol. They've run Operation Nerds for 7 months. So far ~2.5 million pirates have been sentenced. Countries around the world have agreed that a pirate should get the capital punishment. R.I.P.