Time Splitters - no video

[provod2000]

For some reason Time Splitters UK legit disk not showing the video on enigmah (29 wires). Sound is OK though. Plays fine on non modded box. What could it be?

Cheers

Provod

[photek1000]

Is your modded box in NTSC mode, if so these are the symptons, use video switch to put it into PAL and it will play back fine.

[Sweguy]

Hi there! I got the same problem too. I´ve downloaded Timesplitters 2 and extracted the ISO file. Copied all of it to my xbox harddrive. When i start the game i hear music and also some noise when i press the buttons on the game pad. But i get NO picture!!
By the way the file i downloaded was named with "project X". Is it cracked in some way or?
I´m using evolution X and i got the first version of X-cuter chip.
How do i switch Video modes? Must i do it everytime?

[kracken]

try looking for this ....

video_select_v2.rar

burn to disk ( or extract to appz folder on xbox hdd ) , then run it and you will get the option to select PAL or NTSC , reboot xbox and pop game in and play . It will stay this way untill you change it again

[Freaky]

yep i had the same problem with nightfire, it wouldnt work until i changed the mode to ntsc, as as for doing it every time m8, well i havent changed it back yet since i did it, but if you get another of your games that wont boot then you will have to change it back.

but dont worry it only takes 20 seconds tops once you have it burned to a disc, or on your hard drive.