I took off the two amtels on the mem stick so that I can get ppv on a funcard, but one of the pads have come off, as the chips don't have to be put back on the mem stick will I have any probs?
eezzee
I took off the two amtels on the mem stick so that I can get ppv on a funcard, but one of the pads have come off, as the chips don't have to be put back on the mem stick will I have any probs?
eezzee
only 1 way to find out m8
______________________________
disclaimer :- i do not condone or take part in hacking cable co's. i am purely providing info for educational purposes only. what you do with the info is entirely up to you. be warned.
______________________________
Done the same thing myself it will work fine well mine does
Getting 8888, I'm hoping it's just a short a nothing else..
eezzee
I got that too its just a short, get the magnifying glass and solder braid out.
To prove its the simm module leave it out then power up the box and if pace appears it's the simm Also i found that using a gas soldering iron with a hot blower attachment and using the feeler blade to apply upward pressure works really well and quick.
I found that using the feeler blade to saw the amtels nearly always causes a short. Also i only lift one end of the amtels so it will be easier to solder back if an update is required in the future. Good luck
Last edited by BILKO1; 9th July 2003 at 12:03 PM.
thanks guys for your help, I'll get my mags out and find them there short.
I'll also just lift one end of the amtels in future.
eezzee
Don't kill ya 4 chip simm swap it for the later 2 chip simm if you can find one.
THansks m8, never even thought of trying that, works a treat
eezzee
It seems to work on all models except the 4001 you get error 18.
It also stops the 1111 kill command working.
Just opened a 2000 model with no simm anybody seen one before?
:oneeye:
yes the 2000 dont have sim
ram is on board
Some do have simm cards this is the first i have seen without?
I have a 1000t and wish to downgrade to CR1
however I have heard that the above method cannot not be done on my box (apparently its its just like a phase 1b box) and I have to solder one leg from amtel to + battery blah blah etc. could someone please confirm this.
cheers
lift leg 11 on both amtels connect both to + on battery
After downgrade!!!!!
So ths is the method I would use with a 1000t box?
is this what you did?
Social Networking Bookmarks