miniSDK advanced mode

**hatstand** · 9th July 2003

I put "my.hex" into the "memory data (Base code) the top one.
The TW int ep.hex" into the internal eeprom, the middle one.

What other settings do I need to set. ie the commands bit on the right of the screen.

I know I'm doing something wrong, but can't find a clear answer. Ha sanyone used the miniSDK ans miniSDK beta 2.5 to program a funcard4. If so please please either tellme how to do it or PM me.

Thanks

**macy** · 9th July 2003

Just load the hex's & blow ....(click top one) ...I think if you are using xv2 or dis in the readme it tells you to load the "my hex" into the int eprom & the other into the basecode ..I know its the other way round for the rst's hex...Macy

**BILKO1** · 10th July 2003

Select you card type from the drop down menu (top right) then i always blow boot loader+Ext Eeprom+Base then hit do it. I use rst hex generator. What problems are you having???

**hatstand** · 10th July 2003

Thanks for the pointers. And a big thanks to planeman for writting a section on how to sort the NetID out. It worked by cricky.

I put programmed the card as per instructions, put the funcard4 in, but can only get the main radio channels, R1, R2 etc and frontrow.

I've set the netID and the frequency rate. Could it possibly be the symbl rate, you can probably tell that I'm clutching at straws but I'm so close.

After a few minutes of radio I pushed the TV button and all three green lights on the cable box started flashing and it blinked through loads of different channel numbers. But still nothing, just radio and frontrow.

Could it be he hex?

Any help would be greatly appreciated as I'm now stuck as to what to do next.

I've also just found out that if I try to get into the eng menu the box just updates as above???
It's a 2000 NTL in a TW area!

**semirch** · 10th July 2003

Seem to remember that you can@t convert an NTL 2000 box to work in a TW area - something to do with modem speeds, they just keep re-booting every few minutes.