Here's mine...
Drill Mast
6 metre rod pull capacity
Capable of angles from vertical to 450
720mm mast dump
Standard hydraulic mast raise cylinders
Diesel Engine
John Deere JD4054H
1040.5kW (1400 HP) @ 2400 rpm
Rotation Head Standard
JKS / UDR B15 chuck drive
High - low manual gear change
100 - 1500 rpm stepless speed control
487 - 1026 rpm low gear, 708 - 1500 rpm high gear
Water to oil lubrication oil cooler
Rotation Head Output Torque
14540 Nm @ low rpm for maximum breakout
6910 Nm @ 1026 rpm
4750 Nm @ 1500 rpm
Head Traverse
Direct coupled hydraulic cylinder
Maximum speed 30 m/min upwards
Swing out rotation head
Pull Down
53.2 kN (12,000 lbf)
Pull Out
89 kN (20,500 lbf)
Main Hoist
Maximum pull 64.9kN (14,600 lbf)
Maximum speed 120m/minute
Failsafe brake mechanism (spring applied, hydraulic release)
Load sensing motor allows maximum speed for weight
Water Pump
FMC (Bean) L0618HV
175 l/minute @ 2450 kPa
57 l/minute @ 7000 kPa
Rod Break Out
Using rotation head
Maximum torque 2230 Nm (1640 lbf)
Rod Clamps & Slips Table
Hydraulically operated, self energising rod clamp
Easy to remove jaws
Common jaws from 44.5mm to 177.8mm
Wireline Winch
Capacity of 1000m of 5mm wire rope
Maximum pull 7.8kN (bare drum)
Maximum speed 300 m/minute (full drum)
Hydraulics
Highest quality axial and radial piston pumps and motors
Three main open loop hydraulic circuits
Full flow 10micron Beta rated return oil filtration
Larger than average hoses and control valves
Rod Spin Guard
Cages off the rotating rods from the operator
Hydraulically interlocked with rotation
Reduces rotation speed to 100 rpm when cage is opene
Depth Capacities
Diamond Coring
BQ - 1100m
NQ - 870m
HQ - 575m
Social Networking Bookmarks