libdy and orig cards...info

[steve_stoke]

can you get the bk using libdy off an orig card its a v10 rev a16 the box is a 1001b cr2 ntl...if so how.....thanks.... :nowords:

[mitchtech]

nope dont think so look :

select 'Options', then 'Quick Command'. Enter " = " or in 'command letter' and " 0 " in 'Payload'. (That's zero not the letter). Your box should then respond with the IRD and loads of numbers (If your lucky !). What you have just tried to do is obtain the IRD & BK with Libby. It may not have worked if your box has been updated. If it has worked and you have some numbers to look at, then the first 8 digits form your IRD ending in '12' , The next 16 digits are your BK ! This will only work if the software in your box is cr1. You can see the software version your box is using by looking at page 2 in the engineers menu, 'Code Release Version' is what to look out for. If the above doesn't work at all then try "<" in 'command letter' instead of " = " and "1" instead of " 0 " in 'Payload'. This command tends to work better with DI1000/2000 boxes.
not 100% guarunteed to wk but if its a rom 10 rev 16 ure better off trying nagraedit.

[steve_stoke]

thanks...i can get the ird off but where is the bk.?will look again see if i can find it

[mitchtech]

as i said if its cr2 i you may not with libby, its totaly hit n miss.

Get it read on a pheonix programmer using nagraedit for the boxkey m8.

[speccy]

If the card is original and rev16 then get details from card instead using Nagra Edit.

[DAVEY26]

noobs are just too lazy to do a search.
think it would be best to take down the 'SEARCH' feature mod's what ya recon
cos no **** uses it.

dave

[nickpat]

any one know wher i can get Libdebug (libby)programmer