no asking for atmel dump's m8 do it by pm or msn but not in public.
no asking for atmel dump's m8 do it by pm or msn but not in public.
Last edited by the_wizzard; 13th October 2004 at 11:15 PM.
Box works for so many hours then pic goes black, box still functional...
Nothing wrong with card (fun)
now and again i get error 1, when i unlug and plug bk in ..
if i re-flow the atmels and wait say 5 minutes then plug bk in a get picture for a hour or so again.... HELP im stuck...
if anyones got wot i want please PM me for my msn... ta
sorry wizz wasnt thinking...
Last edited by Locksmith; 14th October 2004 at 03:46 PM.
Sounds very much like an atmel problem, either a short, bad contact or a faulty chip. Sometomes a reflow wont help as there may be a pin or 2 not lying flat so you have to use a fine tipped soldering iron and a good magnifying glass. Use plenty of flux to help stop from bridging. Pay special attention to the corner pins which sometimes stick up slightly and give an err 1.
Speccy
reprogram right hand chip only if reflow (1-24)of that chip fails
Social Networking Bookmarks