Fitting EZF IV lite cart into the lite dummy cart

[{{909}}]

thought this deserved its own thread as its a pretty cool mod, hopefully we can get some info together and work out how its been done.

http://www.youtube.com/watch?v=wZuF-...rch=EZ4%20Lite

[Bensons]

I thought of that as soon as I opened the ds box and saw how well made and good looking the dummy gba thing was. Don't think I've got the balls to try it just yet though.

[canardo]

well Ill be attempting to work out how its done over the weekend will let you know how I get on.

[Bensons]

May God be with you my brother.

[_Belial]

I had a go at doing this mod the other night, i cut out pretty much everything inside the dummy cart, all the little ridges but it's still a squeeze, i think i need to grind down some of the plastic some more for a better fit. Or remove the battery and reattach it to the right a bit (there's enough room to fit a battery in there and make a much better fit)

But the problem is the ezflash was too high so the cart still stuck out a bit, so either i've got to grind down the top part a bit or cut a mm or so off the bottom of the ezlight.

Will have a go when i have some time at weekend

[Keva]

what you gotta do

the most important part is the sprayed part where you have to shave it down almost to the clear plastic of the original GBA dust cover

then you have to make holes for A and B to correspond to the original design, rest of the red boxes is where you obviously have to shave with a dremel or some other tool



and i used a sharp tweezer to unscrew the triwing, its pretty easy and requires no strength so you dont bend your tweezer tips

also you will have to glue it for sure cause i dont see any way to screw it together again....but i see a potential if you have the right tools, a very small drill bit for plastic (so it wont crack it) can make a self screw hole

if you are worried about what if your microsd card gets stuck in there and you'd have to break it open to take it out, either use a tweezer again or put some tape to make a flap on your microsd card so it pulls out like a tape tab on the end

From the EZ4 forums.

[{{909}}]

excellent, pity we have to glue it together tho, i want a lite to do this mod

looks like a mm could be shaved off the edge connector too, if thats possible without ruining the board

[_Belial]

Probably worth investing in an extra couple for playing with

http://store.nintendo.com/webapp/wcs...ProductDisplay

[{{909}}]

heh, good to know thees a spare available if you make a mess of your originals

[Bensons]

So... Canardo..? Anyone???

[canardo]

I havent attempted mine yet as it didnt stick out anywhere near as far as I thought

[Bensons]

I want to get my ez-4 into the dummy cart so bad. It'd look so cool!