Benq port VIA card

[Drogo]

This is a copy of my msinfo32

System Information report written at: 11/03/07 13:37:15
System Name: MAIN-PC
[SCSI]

Item Value
Name VIA VT6421 RAID Controller
Manufacturer VIA Technologies, Inc.
Status OK
PNP Device ID PCI\VEN_1106&DEV_3249&SUBSYS_32491106&REV_50\4&13699180&0&3048
I/O Port 0x00008000-0x0000800F
I/O Port 0x00008400-0x0000840F
I/O Port 0x00008800-0x0000880F
I/O Port 0x00008C00-0x00008C0F
I/O Port 0x00009000-0x0000901F
I/O Port 0x00009400-0x000094FF
IRQ Channel IRQ 16
Driver c:\windows\system32\drivers\viamraid.sys (5.1.2600.520, 90.50 KB (92,672 bytes), 05/03/2007 22:27)

Name D347PRT SCSI Controller
Manufacturer (Standard mass storage controllers)
Status OK
PNP Device ID PCI\D347PRT\0000
Driver c:\windows\system32\drivers\d347prt.sys (3.47.0.0 built by: WinDDK, 5.13 KB (5,248 bytes), 17/09/2007 09:32)


I take it that this is the port my card is on (8000)]

Does this look correct

[braymond]

mate if use auto mode you dont need the port number
worked fine for me
just type dosflash if using 1.3b

[Drogo]

seems even though msinfo32 reports it at 8000 - it is in fact 0960 ...

[Drogo]

Benq flashed and working .. neat