i got a 2002 civic cluster and am trying to do an odometer correction..
i found the eeprom, i soldered 2 oscillators together, but everytime i try...the diga tells me.. something like
data not matching, adjust km
i got a 2002 civic cluster and am trying to do an odometer correction..
i found the eeprom, i soldered 2 oscillators together, but everytime i try...the diga tells me.. something like
data not matching, adjust km
Remove the eeprom. Read, goto Show press B to verify and then save. All will be well.
ill try
this is the right way to do it correct..
i did,
Digi ---> extension --> Board with Port 0 1 2, connected cable to port 0 (red line at pin1) to eeprom, red line at pin 1
but like i said, makes no differnece whether its on or not.. i get same reading
Last edited by user; 28th September 2008 at 08:24 PM.
When you go to show is they any data showing? you may have a broken wire ?
ill check and report back,
Social Networking Bookmarks