Just wondering should I give this a go before I bite the bullit and buy a new 360.
Whats the success rate, has anyone had the no picture problem.
Just wondering should I give this a go before I bite the bullit and buy a new 360.
Whats the success rate, has anyone had the no picture problem.
If its the 3RROD then aye, splash out a couple of quid on the screws and washers. You might just find your fine.
Done a few and all worked. Rest of the lads in here also have a good pass rate with the fix.
The most time consuming bit is getting the chips cleaned! Really its easy.
Yep xclamp will fix this. Make sure you use a heatgun on the cpu,gpu and anna/anex chip.
Also to clean the chips, invest in some Akasa Tim Clean. Works wonders.
-=AD=-
well im gonna order it anyway,
dont have 3 rings though just no picture, but if I heat up the 360 the pic comes back then after an hour or two it go blank again
GPU Xclamp should sort this and xecuter pads for good measure. As AD said heatgunning those chips will help reflow the board, or if you aren't comfortable with that overheat it til 2 red lights.
Social Networking Bookmarks