Protecting Your Ambit 250

[Raptor]

how to change the serial number of the infinite firmware:

power up modem with-out feed just ethernet
now open hyperterminal and set your settings to:
connect using = [TCP IP (winsock)
host address = 192.168.100.1
port number = 23
and login in with user & pass
then copy and paste the stop scan cmd:
Code:
cd \cm_hal
scan_stop
cd /
cd non-vol
cd snmp_cm
docsDevSerialNumber cmxxxxxxxxxxxxx (replace the xxxxxxxxxxxxx with any number u like)
write
reboot modem.
Changing The USB MAC.
power up [modem] with-out feed just ethernet cable.
now open hyperterminal and set your settings to:
connect using = TCP/IP (winsock)
host address = 192.168.100.1
port number = 23
and login in with user & pass
then copy and paste the stop scan cmd:
Code:
cd \cm_hal
scan_stop
now enter the following cmds:
Code:
cd /
cd \non-vol/halif
usb_mac_address 00:11:22:33:44:55
write

[up for it]

apart from the serial num this is a bit outdated tbh

downlod 250 configerater or ambit tool and change mac and login/pass with that much easier and faster tbh
only my opinion

[burner1]

apart from the serial num this is a bit outdated tbh

downlod 250 configerater or ambit tool and change mac and login/pass with that much easier and faster tbh
only my opinion

THat's how I do it as well... just use the tool and run the console option.