I bought one of these last week and today it turned up
It's only for the A110 users out there
Basically it enables you to turn on the pch with the remote just as it should have been out of the box
If you have the A110 with out the red power switch on the rear then you'll need to do a little bit of soldering
you'll need to remove a poly fuse and change one of the legs location and then fit in a 2 pin header which is supplied
Once this has been done it's as simple as plugging it into the header and then the sensors sit onto of the led and rf sensor (very easy to do )
If you have one of the newer A-110's with the power switch on the back then it's really easy you you have to do is push the board onto the header and plug it in and away you go.
Now when i turn off my pch using the power then delete i can turn it back on again using the remote rather than finding a pen for 10 minutes to push the little reset button
More info on it can be found
NMT forum
PPM forum
Social Networking Bookmarks