orig.bin file failed md5 hash check

[pau1777]

I am trying to load the latest ixtreme v1.6 no stealth firmware updating from the normal 1.6 firmware using jungleflasher, I have followed the instructions to get my key using the dummy.bin file and it has worked great, the key is there.
When I get the message do I want to auto-load the firmware, I click yes and I get this message "orig.bin file failed md5 hash check"

I have tried everything and I am still having this problem, can anyone help?
Thanks in advance.

[bcuk]

Don't use the autoload instead select open target firmware button in the firmware tool 32 tab and browse to the non stealth firmware and then spoof source to target then save to file.

[tronads]

Whilst bcuk is right, you don't autoload the target firmware, Id be a little concerned that the error message seems to be indicating to an issue with your dumped fimware ("orig.bin"). I would be flashing your new unstealthed hacked firmware onto another drive first to test it, just in case....or at the very least, making sure the key you are seeing matches the one taken (and backed up) when your drive was first flashed.

[pau1777]

Don't use the autoload instead select open target firmware button in the firmware tool 32 tab and browse to the non stealth firmware and then spoof source to target then save to file.

That worked great!
Just tested with Wave 4 game and loaded straight away! Easier than having boot disk.
Just need to wait until LT is available now.
Thanks again.

[biggy7]

Don't use the autoload instead select open target firmware button in the firmware tool 32 tab and browse to the non stealth firmware and then spoof source to target then save to file.

i was about to ask this same question, was having the same problem and this worked a treat

Thanks!