i need help AGAIN......
i think my M/B is fecked!!!
when i boot up it locks on the start up screen and says cheksum error or checksum bad or even something about my setup not being valid, underneath this it says ... <ins> pressed
if i go into the bios setup and come out it will try to load but will at somepoint say it cant find a file or that a fault has occured..usually "when initialising device vkd and error occured@ and it requires windows to be reset due to protection error!!!
tried removing battery to flush bios and start again but it wont clear...
one thing that does ahppen is that if i do make changes in the bios and save and exit after the protection error if i reset the changes are not there??????
another interesting thing is that at the bottom of the start-up screen you usually see a line of numbers etc...well when i try for first time i get like 6 or 7 lines of numbers mostly zeros and stuff about my board i.e usb 1.1 blah blah, but after i have been in the bios i get just the normal line of info, until it fails to load then its the same junk again!!
oh yeah i tried to flash the bios and after a hundred attempts to get a command prompt , it kept freezing when i tried to use the winstart-up disc and wouldnt let me select an option, i succesfully flashed the bios so it said but it still does the same old crap!!!!
any help wouild be much appreciated!!!!
thanks
crazy
Social Networking Bookmarks