I'm sur it's been asked a million times but i would appreciate it if someone would point me in the right direction.

I have an 8210 v5.28 that I want to unlock. I have a Flasher cable(the type that fits on the printer port).

I was going to use Jetro 3.11 and link the two pins 7 & 12 in the cable, however I notice in the about for jethro that it only supports up to 5.26. Will it still work??

If not whats my next best move - use a partial etc?? I have done this once before but i would not say i'm over confident (Do you have a good Tut)

Should I order another cable instead??

Thanx