Question on X-ecutor

**gauz** · 27th August 2002

Is there another spot to solder the "one wire" to if the existing spot has lost its small pad from overheating?

**_xboxer@1_** · 27th August 2002

No But what you can do is, take a razorblade and scrap gently and carefully some of the green stuff on the actuall line that goes to that hole. then soldier on the line... it will work.

**=Ichijouji=** · 27th August 2002

Actually, there is an alternate point.

Use point #9 from the OpenXbox diagrams, it's on the underside of the motherboard.

**gauz** · 28th August 2002

Do you have a address for the diagrams?

**jsmith-34** · 28th August 2002

check xbox-scene they have couple pictures in the forum section

**soulcrushR** · 28th August 2002

Originally posted by Ichijouji
Actually, there is an alternate point.

Use point #9 from the OpenXbox diagrams, it's on the underside of the motherboard.

fyi, you _cannot_ use this as an alternative solder point if the original point has been melted and not properly fixed.