Whats the best wat to correct the mileage on a 02 plate almera, What order do i connect the sw13 cable to the board if it can be done this way
any help appreciated please
Whats the best wat to correct the mileage on a 02 plate almera, What order do i connect the sw13 cable to the board if it can be done this way
any help appreciated please
Managed to do it myself, the support on here for correction is wank
Go and fuck yourself.
People may be busy who usually help out in this section i hate pricks like you!
correction hahahahahaha.
twat.
You can't do the job that YOU take on, then YOU slag everyone else off cos they have not replied to you. waste of space I wont ever replied to any post that you put on!!!!!
Just had a look at your posts all you ever do is ask this, ask that, do you ever give help to anyone else !!!! ?
Ok let me inform you all how i did it using tacho universal, 2 crystals on the board have to be joined up, i used the small smd clip and menu in tacho was almera - 2001 - s93c66, currant value will be a lot of rubbish just go ahead and change KM, will show working for around 5 secs then report data unequal but as long as it reported working for a min of 5 secs it will have worked just ignore data unequal message, if the currant value is 00000000 then you have a bad connection or if it goes into working mode for less than 5secs you have a connection problem
'Data not equal' means not all the data was witten back to the eeprom. May have an effect or may not depends if data not written is addressed to by the CPU or not. Effects can be dials not working correctly etc.
This is likely to be because the chip was a secure eeprom, these should be removed or they can lock.
Social Networking Bookmarks