Prassi PrimoDVD Options Problem
I'm using Prassi PrimoDVD v2.0 Build 2.0.749 on WinXP Pro Service pack 1. No problems burning discs, that's fine, but when I try to go into options I get the following: - "Run-time error '9' subscript out of range" then when you click ok the program shuts down. Has anyone encountered this problem and if so what's the solution. Thanx in advance
I've had exactly the same problem and it was caused by flashing my 40x LiteOn to a 48x.
Disconnect all your recording devices from the IDE bus and plug them back in one at a time while trying to get to the options screen, when it falls over then you have found the device causing the problem.
Make sure you switch your system off before attempting to disconnect or re-connect your devices!!
Understeer is when you hit a wall with the front of your car
Oversteer is when you hit the wall with the back of your car
Horsepower is how fast your car hits the wall
Torque is how far your car sends the wall across the field once you've hit it
I also have a Liteon 40x although I haven't flashed it to a 48x. Didn't know you could. Could this drive be causing the problem, it's supposed to be supported
It was the Liteon drive causing the problem. I disabled it in device manager and the options now work. There's nothing I wanna change in there anyway now I've seen em! Guess I'll just enable drive again and never bother looking at options again! Thanx for your help Pegasus, much appreciated.
No problem
Understeer is when you hit a wall with the front of your car
Oversteer is when you hit the wall with the back of your car
Horsepower is how fast your car hits the wall
Torque is how far your car sends the wall across the field once you've hit it
Posting Permissions
Reply With Quote
Social Networking Bookmarks