Ok went to flash my sons elite (havent done any in a few months) found out that it wasnt straight forward (its a 93450 Liteon) ordered the LT Switch 1.5 ..soldered it in - didnt work (my dodgy soldering) - cleaned it all up and did it again now I get the green light on the switch but my drive wont show up in Jungleflasher anymore - PLUS Ive noticed it wont eject when using the eject button on the CK3 I took the switch off again to test it and hooked it back up to the CK3 (without the switch on it) and it still wont eject or be seen by Jungleflasher? have I screwed something up? or maybe cutting the tracks that are needed to be cut stop it from ejecting? - I ve searched for an answer but not found anyone having the same problem..
Any advice would be much appreciated!