Thanks for the tips Burner, I did also hear that if a WPS router had never been connected with its pin it will give me that issue. I must admit I have never used the WPS on it so that must be the problem. I will try the command line you gave me when reaver has finished doing my friends router which is next door and I already have the key for.
I have been messing around with Xiapan which has Reaver built in, it gave the same results on my network so it obviously works. Its a nice point and click interface with all the Reaver feaures there to be selected without the need to remember any command lines. When you first run it, it shows you all the AP which are WPS enabled and are good to go, so saves on the Wash command. The only problem I am having is thats its been running nearly 2 days now and is only at 25%. Also for some reason on the AP its not showing what pins have been tried on the progress report. Its not as if the signal is weak (-65db). at this rate its going to take a week. Its a Virginmedia router
Social Networking Bookmarks