Bosch 2-28 DV SDS+ Hammer Drill. Help finding information
Ok, I have one of these.
I want to make sure I am fitting the SDS+ bit correctly.
The manual is all well and good, but pictures only. I have been on youtube and just found videos showing it off but not changing and how to change bits!
When I fit a drillbit, I get it to a point where you cannot PULL it out BUT it moves about 10mm back and fourth. Is this down to the hammer action?
I was using rotary only and still had this movement. Worried I am not fitting things correctly.
I would really appreciate a video link if possible, perhaps to a similar Bosch SDS+ drill
Cheers.....Q
Social Networking Bookmarks