Evening all I have a civic with abs light on is there an easy way to check for faulty sensors? Thanks
jag
Evening all I have a civic with abs light on is there an easy way to check for faulty sensors? Thanks
jag
I'm not racist i hate everybody
check each sensor with a multimeter if they show open circuit there buggered they should show a resistance which off the top of my head can't remember what resistance it is
easiest place to check the resistance is from the first connector just follow the wire from the sensor at the wheel
good luck
jaguar982 (9th August 2014)
All the gear no idea
What do i set the multimeter onto
Sorry to be a pain
jag
I'm not racist i hate everybody
set multimeter to the ohms scale and if selectable something like the 1K ohms scale.. as long as you get a reading it's not open circuit
look here mate https://www.youtube.com/watch?v=7eCJa7JZzfg
supe
jaguar982 (9th August 2014)
set the multimeter to Ohms 2k ( 2000 ohms ) should do
EDIT..
ah i see supermans beat me to it
jaguar982 (9th August 2014)
jaguar982 (9th August 2014), supraman54 (9th August 2014)
Just spent half my day stuck under the car inbetween the rain 2 broken bolts later moved on to front on the O/S/F it carries on to overload so i may have found it, if i leave it disconnected would the light go out or can i override it to check
thanks to everyone so far for your help
jag
Last edited by jaguar982; 17th August 2014 at 07:08 PM.
I'm not racist i hate everybody
If it's unplugged, open circuit so light comes on when ignition is switch on and self check starts.
Lots of my repairs and pictures of retro stuff on my twitter.
https://twitter.com/Big_ted1?t=s9zEZ...Z-npEyeKA&s=09
Bit late perhaps, http://www.civicforums.com/forums/18...abs-codes.html
Forgot about blink codes.
Lots of my repairs and pictures of retro stuff on my twitter.
https://twitter.com/Big_ted1?t=s9zEZ...Z-npEyeKA&s=09
Thanks Ted i will plug it back in but i dont have a management light on so not sure it will show a fault code will it?
Jag
I'm not racist i hate everybody
The abs light should flash the codes.
Lots of my repairs and pictures of retro stuff on my twitter.
https://twitter.com/Big_ted1?t=s9zEZ...Z-npEyeKA&s=09
jaguar982 (18th August 2014)
No joy ABS light still on i have removed 7.5 fuse to reset memory and crossed jumpers no blink codes on abs or cel just joined honda forum cos my mot is up this week :-(
jag
I'm not racist i hate everybody
Fault code 11 O/S/F wheel sensor (open/short to body ground/short to power)
on mine i only have 5 pins that threw me but i cross pins 3 & 5
thanks Big-Ted
jag
I'm not racist i hate everybody
Social Networking Bookmarks